Vector frequency converter 220 to 380, 11 kW of the SPLC-NZ2200 series is designed to control the speed of rotations of three-phase asynchronous motors with up to 11 kW power.
The feature of this converter is a built-in unit for increasing output voltage. The frequency converter is connected to an ordinary single-phase network 220 V, while the output is connected to a three-phase motor 380 V with a star winding connection (necessary to maintain nominal torque on the shaft).
This model of frequency converter SPLC-NZ2200-11GS2 has a protection degree of IP20. Therefore, it is recommended to install it on a DIN rail in specialized cabinets for protection against dust and moisture.
The control panel, if necessary, can be removed and placed on the front panel of the cabinet. Cable and mounting are not included in the price and are supplied on request.
Table — Main technical parameters of the frequency converter SPLC-NZ2200-11GS2
| Input Voltage |
1ph 220 V
|
| Output Voltage |
3ph 380 V
|
| Output Power |
11 kW
|
| Output Frequency Range |
from 1 to 800.0 Hz
|
| Protection Degree EN 60529
|
IP20 |
Additional Information
Power Circuit of Frequency Converters SPLC-NZ2200-11GS2:
- Input power from a single-phase network 1ph 220 V AC current 50/60 Hz;
- Output to the motor - 3ph, line output voltage ranges from 0 to 380 V, and frequency - in the range from 1 to 800 Hz;
- Permissible overload for 60 s - up to 150% of nominal current (in constant load mode)
Control Circuit SPLC-NZ2200-11GS2:
- 6DI — six digital inputs, the function of which can be independently defined through menu selection. For example, a digital input can be used for a start command, forward run, reverse, stop, frequency JOG skip, switching between frequency sources X and Y, switching between 16 preset speed frequency values, switching between 4 acceleration and braking modes, remote frequency increase/decrease, timer start, PID control activation, embedded controller program, etc.
- 2AI — two inputs, one can be switched using the J jumper to receive the corresponding analogue signal by current 4…20 mA or voltage 0…10 V, while the other supports 0…10 V;
- 2DO — two multifunctional digital outputs, one of which is relay to be used for an output signal ON-OFF about operating state, frequency or time counter achievement, program step or cycle completion in PLC program;
- 1AO — one output that supports analogue signal by current 4…20 mA or voltage 0…10 V;
- RS485 — RS485 serial port connector for integration into an industrial set of frequency converters NLP, controllers, industrial PCs, etc.
You can buy the frequency converter SPLC-NZ2200-11GS2 with a power of 11 kW from the company "Specialist" with delivery to Kyiv, Dnipro, Kharkiv and other cities of Ukraine. Delivery time should be checked with the online store managers.
Attention! Check the possibility of connecting a braking resistor to this model.
In Stock
